Archive of ‘Plumbing Maintenance And Repair’ category

Sound Advice For Plumbing Maintenance And Repair

Professional plumbing is often a very expensive service, and usually the work that is done is something that any homeowner could solve fairly easily with the proper knowledge and tools. If you’d like to start learning to solve your own plumbing problems, read on to see what you can do.

If your pipes bang when you turn on the water, and all the pipes are anchored correctly, you should add some straps or cushion the pipes with a rubber blanket. There may be times when you will need to do both. Make sure that if you have copper pipes, you are not using galvanized straps.

If your toilet is slow to flush, add some white vinegar to the overflow tube. White vinegar helps the water from your tank to flow quickly, which will make the toilet flush faster. It is recommended that you use about a quart of the vinegar and let it stay there for at least an hour before flushing.

Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.

Got a leaky pipe? In many cases you can repair this yourself without the expense of a plumber. If a joint is leaking, tighten it with a pipe wrench. If the leak is coming from a damaged section of pipe, you can try repairing with a store-bought patching kit. One method involves applying waterproof tape to the section of pipe where there is leakage. Before applying the tape, make sure the pipe is thoroughly dry. Make sure that the tape covers two to three inches on either side of the breakage in the pipe.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place. Have a peek at this web site about at plumbing.

As you can see, plumbing isn’t as difficult as you may have believed. Many plumbing problems can be solved easily with things on hand, or with a few inexpensive parts. Next time you have a problem with your plumbing, try using the tips in this article to solve it yourself!